By Levi Morgan
The popularity of "paper tuning" bows has grown over the last few years. There is more and more information out there about tuning bows, which is a good thing.
Paper tuning, especially with a bare shaft, will help you determine if you have the proper bow setup for ultimate accuracy. Ideally, you should be able to get perfect tears at 20 yards with or without vanes.
When I was growing up, paper tuning was pretty much nonexistent. For those who don't know what this is, it is simply shooting an arrow through a piece of paper to see if it is traveling straight or kicking sideways as it comes off the bowstring. The only problem with this is that sometimes the vanes can contact the riser or rest and you can never get a perfect tear (bullet hole) no matter what you do. On top of that, the vanes can act as a Band-Aid, covering up or slightly correcting the actual tune of the bow. I take paper tuning a step further now. I shoot an arrow through paper that is the same length and weight as my others, but this one will have no vanes. In the archery world, it's called bare-shaft tuning.
You can either leave one shaft unfletched when building your arrows, or you can take a razor blade and scrape off the vanes on one of your current arrows. The main thing is to make sure it has the same specs (length, weight and spine). Obviously, when you take the vanes off, it will weigh less, so I like to take electrical tape and wrap the arrow exactly where the vanes were until it matches the weight of my other arrows. Don't wrap the tape anywhere else on the shaft, because it's important that the arrow spine (flex) remains the same.
Advertisement
Then, walk up to about two yards from the paper and shoot through. I like to shoot very close because I want the initial reaction right out of the bow. Depending on the tear, you can adjust your rest slightly. Sometimes, tears that are high can mean the spine is too weak, and low tears would be the opposite. If you get a bullet hole at two yards, then you know from the start the arrow is coming out perfectly. When you shoot a fletched arrow through, it should also be a bullet hole. If not, then you have a clearance issue. Your vanes must be contacting either the riser, cables or rest, causing them to fly off plane. I won't get into that here, but spray some powder such as athlete's foot spray all over that area, and it will show you exactly where the vanes are hitting.
Bare-shaft tuning is the best way to see if, when uninfluenced by the vanes, your bow is properly tuned. Ideally, when a bow is properly tuned, you can take an arrow with vanes and shoot an X at 20 yards and then take an arrow with no vanes and do the same. It will show you if your setup is perfect or if you still have some work to do. I'm not saying you can't shoot well with a bow that doesn't shoot a bullet hole, because that's false. I've won national championships with bows that weren't tuned perfectly. That being said, as a right-hander, the only tear I'm OK with is slightly high left, which means the back end of the arrow is getting away from the riser so there will be no clearance issue. The opposite would apply to left-handers. Having a paper-tuned setup isn't the magical answer to making you a great archer, but it will most certainly be a step in the right direction.